ODES Speed Controller 2-plug Connector with 2-Wire
This is for 10109360001
others below;
*Only 1 Plug Limiter Box = 10909360001*
**2-Plug Limiter with 1-wire = 10109360000**
Factory HiSun FLYWHEEL (Magneto) PULLER 28mm
FITS MOST ATV - UTV 250 MODELS 2015-2024
We Now List Many HiSun Special Tools !
This PULLER is needed to Replace or Remove the Flywheel
This is the 450, 500 Rear Drive Shaft that connects the Engine to the Rear Diff. Approx. 5" long.Splined Ends Measure; 24.3mm O.D and 34.8mm O.D.
This is normally found behind the Starter Clutch Ring Gear. 25.3mm I.D. x 39mm O.D. x 1.0 m.The newer 1:7 Cranks need the 27mmI.D. washer.
This is the the Spigot type (Round Tube both Ends) most common.
We also Have the Flange type Throttle Body for the Odes 650 Comrade.
- This listing is to sell you parts that are normally not listed.We will change the Title to the Description of the parts needed.
These is the newest type Rear Knuckle that Uses the wide DAC Bearing and Circlip.Fits Late Model Odes X2 - X4 Dominator and AOdes JungleCross and others.
This is for Standard Width Approx. 52" wide. The Wide Body has Double Width Flares for approx. 60" models.This is most common from 2008-2024 including the HiSun, MSU, Coleman, Big Muddy, Super Mach, Q-Link, and the newest AXIS Models.
Complete U-Joint Assy. and both Yokes with 22mm Bearing End Caps. Fits from Front Diff to Driveshaft with 24mm ish Splines.The older Models have 20mm O.D. Front Drive Shaft Splines, this is for the 24mm Splined Drive Shaft.Contact us if any other Yokes are needed.
Complete U-Joint Assy. with 22mm Bearing End Caps and Yokes (A and B) to fits updated 24ish mm Drive Shaft Spline. This connects the Engine Out Pinion to the Drive Shaft.
