-
Finally Arrived ! This is the CV Tech best Primary clutch. The Center has a Full Width Bearing that Locks-Up 1 Diection to give it Engine Breaking even at Idle ! Uses the standard 14mm Puller to remove. -
Factory 1000 Transmission from ODES
This also includes the
Angle Rotation Sensor & Speed Sensor, Engine connecting
O-Ring 21040115801 and Rubber Seal 21040115901
This Transmission is ready to Bolt In and Go ! (Add OIL !)
All Dominator 1000cc UTVs, Ravager 1000cc
X-2, X-4 and All 1000 V-Twin by ODES
(Rear 4-Hole Axle Mount Bolt Hole is M12x1.25 Standard Right Hand Thread)
Remember the 800 and 1000 Transmissions can fail because the clutch system is worn
and allowing the CVT belt to turn at idle, making shifting hard and jumps in gear.
Just make sure the Belt is Not Turning at idle before you install the belt cover.
-
ODES FACTORY STARTER MOTOR
WILL FIT 2011-2019 ODES 800 & 1000 UTV'S & ATVs
-
Out of stock
3-Bolt Hole Front Diff Actuator, also know as Divide Device, Servo, Transfer Case or 2-WD/4-WD Motor. -
This is the Factory CVT Belt. Please inspect before replacing. If the Clutch seems like it is Slipping, is is probally the Interior Wet Clutch. Use these word in the Search Bar ' Odes 650 Wet Shoe' -
Odes 650 CYLINDER HEAD
Complete with Valves, Springs, Rockers
FITS ODES UTV COMRADE
2017 - 2022
-
This is for the ODES 650 Comrade and other Single Cylinder Engines. -
Odes 650 Piston Kit
Piston, Rings, Wrist Pin, Clips, Gaskets
Rebuild it Right and Save Money.
We try to have ALL Engine Parts in Stock !
Please Check Our Other Listings For 650;
Cylinder, Cylinder Head, Clutches and Much More.
FITS ODES UTV COMRADE
2017 - 2022
-
Out of stock
This is the Speedometer Display for the Odes 650 and has 3 similar white 6-prong plugs. Please try a different rotation if not working properly. 3 tries to get it right. -
This Starter for the 650 has 9 Teeth and the Mount Holes are approx. 90mm apart at the centers. The Nose has a 40mm O.D. -
Out of stock
This Sensor has 14mm Threads and the Sensor Tip is 11.5mm O.D. (See Pictures) If you have a 17mm Thread with a thin Sensor Tip of 5.5mm let us know to send that instead. -
This is the Flange type Throttle Body for the Odes 650 Comrade. We also Have the Spigot type (Round Tube both Ends) most common. -
This is the the Spigot type (Round Tube both Ends) most common.
We also Have the Flange type Throttle Body for the Odes 650 Comrade.
-
Steering Knuckle Left
Please Study all Pictures for Correct Version
Front/Driver
Complete with 2 Bearings and 2 Seals
Will Fit Most ODES UTV LONG Travel
UTV 800 & 1000 Raider, Dominator D2, X4
-
Steering Knuckle Right
(Version #2, Please Study all Pictures)
Front / Passenger (Long Arm)
Complete with 2 Bearings and 2 Seals as Shown
Will Fit Most ODES UTV LONG Travel
UTV 800 & 1000 Raider, Ravager, Dominator D2, X2
-
Rear Differential (DIFF)
This Fits most V-Twin 800 ODES 'ST' Models
Also known as Rear Axle Gear Bridge
Fits ODES V-Twin 800 UTV (Standard Travel)
-
This is for the 800-1000, Approx. 2015ish to 2017ish. Normally will see the 2 Rectangle plates protruding though the resin. Hardly Seen on updated Controller. Come with new Remote Fob.
