-
HISUN REPLACEMENT INTAKE PIPE JOINT
This connects the intake manifold to the Throttle Body
It fits HiSun EFI MODELS 500,550, 700, 750, UTV'S
This is for the STRIGHT boot, if you Need the 15 Degree Curved Manifold order # 14802-128-0000
-
This is for the ATV and UTV 700 Carburetor Model with the Step-Down in size.
Fits Yamaha 660 Rhino also, 5KM-13596-00-00.
-
17502-119-0000 Same as 14801-012-0000 same as P012000124010000 Sold Each This is the Small Tube that Connects the Intake Manifold to the 'T' , 3-way Intake Pipe. Measures approx 52.5mm I.D. and the inner Rib is 50mm I.D. It is 1.28" (32.5mm) Long. -
This is the Rubber Joint from the Throttle Body to the Intake Manifold for all HiSun 1000 Models. -
This Rubber Boot is used on the Throttle Body and Intake Tubing on most of the HS 1000 Models.
The Part # 14791-119-0000 is Molded into the outer surface.
-
This Outer Rounded Gear has Inner Splines also. Has Approx. 34.75mm O.D. and 23mm Wide. -
Rear Wheel / Knuckle 'Bearing Kit'
4 Bushings, 2 Spacer Shafts and 4 Seals for (1) SIDE.
(we also have the Front and Rear Knuckle, if needed)
Normal Bolt Diameter is 12mm, if you have 10mm bolt,
please use the 'Search Bar' or message us.
-
Complete with Bushing Bearings and Seals as Shown
Will Fit 2010-2018ish HiSUN 400, 500, 700 & 800 UTV'S
INCLUDING, MASSIMO, SUPERMACH, Bennche, Big Muddy, Q Link
COLEMAN, MENARDS YARDSPORT and More !
UTV 400, 500 ,700 & 800 cc
-
Has a 12mm Bolt Hole and Bushing to mount to the A-Arm
Rear Knuckle Left Side/Driver
Complete with Bushing Bearings and Seals as Shown
Will Fit 2015-2022ish HiSUN 500, 550, 700 & 750 UTV's
-
Has 10MM Holes and Bushings For the 10mm Bolt to Mount to A-Arms, See Pictures.
-
Rear Knuckle Right Side/PASSENGER with 12MM Hole and Bushings
Complete with Bushing Bearings and Seals as Shown
HiSUN 500, 550, 700 & 750 UTV'S
Approx 2014ish - Current
Older models have the 10mm Holes
-
This Repair kit is for 1 Rear Knuckle, replaces Top and Bottom Bushings. The inner Bushing Tube is for the 10mm O.D. Bolt (other size is 12mm) Simply remove the Nut from the upper or lower Knuckle Bolt and measure the O.D. of the threads. It will be closer to 10mm or 12mm. -
This is for (2) LED Head Light Bulbs. -
This Horn Light Turn switch assy. has the Individual plug ends.
Later models have 1-Plug connection. with part # 37530-115H-000 or 57530-115N-0000.
-
This Horn Light Turn switch assy. has the 1-Plug connection.
Earlier models have Individual plug ends with part # 37530-115-000.
