Fits JungleCross, DesertCross, Dominator, Ravager and most Odes that Have the 12mm wheel Studs.
-
Out of stock
This is the Newest Rim for the Late Model Odes that have the 15" Tires. Has the standard 4 x 110 pattern. -
To add or replace, use a Press to remove the spring loaded Circlip on the Spring side end of the Clutch.
Then the 4 Ramps with the Allen Head bolts need to be removed.
This spacer is normally for the ODES 800 that has a Solid Center Roller on the Primary.
This spacer allows the Secondary Clutch Plates to Open which also allows the CVT Belt to drop down and release pressure off the Solid Center Roller of the Primary Clutch.
Remember, the Belt should NOT turn at Idle ! (900-1,100 rpm)
-
This includes the 2 Hoses and the Black Separator Box. No Clams included. (not needed)
-
This Circlip Fits the Inner Spline Shaft of many axles for assembly. It has the I.D, of 20mm or .78" (just over 3/4"). -
Factory Odes 800 Radiator
Complete with, 2 Fans
Fits ODES 800 UTVs
2011-2022 and Many more models
all other 800 Radiators have been Discontinued.
This is the only Odes 800 Radiator that has the Oil Cooler
(some brackets may need to be modified)
Please Study the Location of the 2 Hose Connections
This the Upgraded Radiator and can be Installed on most Odes UTVs
-
Factory Replacement Dual Fan RADIATOR !
Complete with, 2 Fans
Fits ODES 1000 UTVs
2019-2020 and Many more models
Please Study the Location of the 3 Hose Connections
This the Upgraded Radiator and can be Installed on most Odes UTVs
-
These are the Cylinder Head Bolts for the Intake end of the 450, 500 and 550 Cylinder Head, requires (2), sold each. M10 x 261 x 1.25 The Intake Bolts are Shorter M10 x 230. # 90034-004-0000 -
These are the Cylinder Head Bolts for the Exhaust end of the 450, 500 and 550 Cylinder Head, requires (2), sold each. M10 x 230 x 1.25 The Intake Bolts are longer M10 x 261 # 90035-004-0000 -
This is for the Wide Axle Model that is Approx. 60-62" Wide as the Std. Model is 52-54" Wide
Outside to Outside of either Wheel/Tire.
These Axles are 4" wider than Std. and measure approx. 30" and 29 1/4" when compressed.
The Wide Model has Double Curved Fender Flares.
-
This is for the Carburetor Models. All that is available is this ATV version. It has a shorter arm but works the exact same. The Fuel Sensor will show that it is Empty sooner. -
This Gas Cap should fit many newer Models from Applestone that is Distributed by Massimo for the UTV Warrior Fits many Female Neck with an I.D. (inside hole size) of 40mm , just over 1.5". The O.D of the cap is 44mm.
