-
This is the Right side Handlebar Switch for the 4-WD and Thumb Throttle for the Odes ATV. -
To add or replace, use a Press to remove the spring loaded Circlip on the Spring side end of the Clutch.
Then the 4 Ramps with the Allen Head bolts need to be removed.
This spacer is normally for the ODES 800 that has a Solid Center Roller on the Primary.
This spacer allows the Secondary Clutch Plates to Open which also allows the CVT Belt to drop down and release pressure off the Solid Center Roller of the Primary Clutch.
Remember, the Belt should NOT turn at Idle ! (900-1,100 rpm)
-
'REAR Wheel / Axle Bearing Kit'
Both Bearings and Both Seals for (1) Wheel.
(we also have the Front and Rear Knuckle, if needed)
Fits ODES and HISUN UTVs CARB & EFI MODELS 400,500,700 & 800cc
Approx. 2020 some models now have (1) Single Bearing that is Double Wide with No spacer.
-
Please reuse your old weights from each Slider.
If you need the Sliders with the Weights inside search same with Weights.
-
Please reuse your old weights from each Slider.
If you need the Sliders with the Weights inside search same with Weights.
-
This Seal is closest to the Transmission and has a 30mm I.D. The other end seal is 25x47x7. -
This has the smaller I.D. of 25mm, the Transmission end Seal has bigger I.D. 30x47x7 -
ODES Temperature Sensor 3-Prong
This Sensor is Installed in the Cylinder Head.
Fits ODES V-Twin 800 & 1000 UTV and ATV
Dominator, Raider, Assailant
