Please reuse your old weights from each Slider.
If you need the Sliders with the Weights inside search same with Weights.
-
Please reuse your old weights from each Slider.
If you need the Sliders with the Weights inside search same with Weights.
-
This Radiator Cap and Mounts Fits bot the HiSun and Odes Models.
The neck tube is 16.5mm O.D. and the mountung hole centers are approx. 60mm apart.
-
'REAR Wheel / Axle Bearing Kit'
Both Bearings and Both Seals for (1) Wheel.
(we also have the Front and Rear Knuckle, if needed)
Fits ODES and HISUN UTVs CARB & EFI MODELS 400,500,700 & 800cc
Approx. 2020 some models now have (1) Single Bearing that is Double Wide with No spacer.
-
For the HiSun and Odes UTVs.
450-500-550-700-750-800-1000 Left or Right (Same)
This Buckle is the Newest Style Approx. 12.75" Long
(let us know if you need a different length)
We also have the Seat Belt Assy, 3 Point Harness.
IT FITS THE FOLLOWING MODELS: 2008 - 2023
-
UP FOR SALESECONDARY CLUTCH
ODES 1000 FX-3, MXU 1000, Workcross, Warrior
'CV Tech' Factory, CVT, Drive Clutch
TrailBloc
This Secondary Clutch is Larger has been Spring Calibrated for this Model.
Fits ODES 1000 UTV'S with newest engine (see picture below)
that has the Rear Diff and Transmission in the same Cases.
-
To add or replace, use a Press to remove the spring loaded Circlip on the Spring side end of the Clutch.
Then the 4 Ramps with the Allen Head bolts need to be removed.
This spacer is normally for the ODES 800 that has a Solid Center Roller on the Primary.
This spacer allows the Secondary Clutch Plates to Open which also allows the CVT Belt to drop down and release pressure off the Solid Center Roller of the Primary Clutch.
Remember, the Belt should NOT turn at Idle ! (900-1,100 rpm)
